Tension (Bonding strength)

High-Voltage Wire Harness Crimp Terminal Tension Strength Test(Complies with the corresponding part of JIS C2805:2010)

This is pull test on crimped terminal of high-voltage wire harness complying with the corresponding part of JIS C2805:2010. The crimped terminal is continuously pulled at a certain force based on the sample size for 10 seconds. After the test, check if the connector part was NOT pulled apart. It is used for R&D and quality control.
Click here
for Details

Cable Crimp Terminals Tension Strength Test(Complies with the corresponding part of IEC 60512-16-4: 2008 and JIS C2805: 2010)

There are 2 ways to measure the tension strength of crimped terminals, durability test and break test. The break test complying with the coresponding part of IEC 60512-16-4: 2008 requires you to determine the maximum force value when the terminal is pulled off. On the other hand, the durability test complying with the coresponding part of JIS C2805: 2010 requires you to pull the crimped terminal continuously at a certain force for 10 seconds, and check the connector part situation after the test. They are used for R&D and quality control.
Click here
for Details

Simple Corrugated Cardboard Sealing Strength Test

Sealing strength of corrugated cardboard is measured by IMADA's force gauge and a dedicated hook. You just insert the hook into the gap and pull it up until the cardboard is unsealed, the force gauge captures the maximum force value, which is the cardboard's sealing strength. It is used for quality control.
Click here
for Details

Tensile Strength Test of Crimped Wire Terminals (Durability Test) (Complies with the corresponding part of JIS C2805: 2010)

This is tensile strength test of crimped wire terminals (durability test) complying with the corresponding part of JIS C2805: 2010. It is used for R&D and quality control.
Click here
for Details

45-degree Pull Test of Solder Joints on QFP Lead (complies with the corresponding part of JIS Z3198-6: 2003)

This is 45-degree pull test of solder joints on QFP lead complying with the corresponding part of JIS Z3198-6: 2003. This method is used to test the endurance of solder joints for evaluation and quality control.
Click here
for Details

Pull Strength Test of Gull-wing Lead (complies with the corresponding part of IEC62137-1-1: 2007)

This is pull strength test of gull-wing lead complying with the corresponding part of IEC 62137-1-1:2007. This method is used to test the endurance of solder joints for evaluation and quality control.
Click here
for Details

Spot welding bonding strength test

This is spot welding bonding strength test for safety evaluation and quality control.
Click here
for Details

Sewed decoration tension strength test

Decoration is gripped by a optional attachment to measure its tension strength for safety evaluation and quality control.
Click here
for Details

Fabric bag handle tension test

To determine tensile strength of a fabric bag's handle, grip the handle specimen with 2 pcs of dedicated grips, and pull both ends until it breaks. IMADA offers the dedicated testing system such as the following configuration, which is utilized in quality control and R&D.
Click here
for Details

Pull off test of elastic band from face mask

This is pull off test of elastic band from face mask by using IMADA force-displacement measurement unit. It is for quality control and R&D.
Click here
for Details